Hazard Recognition

Weekly Toolbox Talk: Shortcuts

All of us have exposed ourselves to possible injury by taking shortcuts when a few extra seconds would have meant doing something the safe way. We did this as children when we jumped the fence instead of using the gate. We do it today when we cross streets between intersections instead of at corners.

Weekly Toolbox Talk: Close Calls/Near Misses are Wake-Up Calls

At the Marek we expect everyone to report unsafe conditions and actions, as stated in PROJECT SAFE. A near miss is always considered an unsafe condition that needs immediate correction.

Close calls or near misses are all too common in the workplace. Why talk about incidents that didn’t happen? The following story might make it a little easier to understand a close call: You are walking at your job site.

Weekly Toolbox Talk: Floor Openings

Safely covering a floor opening with a piece of plywood requires more than just laying down the material over the hole, or even nailing it down.

Total on the job safety means a total job of eliminating a hazard. Half a job or inadequate or incomplete jobs of covering hole in the floor. Why did it happen?

Weekly Toolbox Talk: Extension Cords

Even a simple extension cords needs to be looked after. It’s a shock or fire hazard when deteriorated, worn-out or used improperly.

Three-wire cords are for outdoor appliances and electric power tools. The third wire is a ground. Never plug these cords into an ungrounded electrical outlet.

Don’t disconnect an extension cord by pulling the cord. Remove it by the plug; otherwise the end frays and loosens.

Weekly Toolbox Talk: Slips, Trips and Falls (Fall Prevention)

Note to Supervisors: Read and prepare. Your objective is to point out the dangers of the most common – AND PREVENTABLE – causes of serious accidents. Explain practices to help avoid these types of accidents. You should hold this meeting on the floor so you can move around and point out and identify possible slip, trip and fall hazards.

Weekly Toolbox Talk: Hazards on the Construction Jobsite

Note to Supervisors: Read and prepare for meeting by looking over your jobsite and how your personnel are approaching their jobs. Using common sense and paying attention to detail can prevent most accidents. Carelessness is not acceptable.

Performing construction work can be dangerous for the inexperienced construction worker. Even experienced workers often forget about some of the hazards of working construction.

Pages

Subscribe to Hazard Recognition

Facebook

Twitter

LinkedIn

YouTube