Weekly Toolbox Talk: Wear Eye Protection Properly

n

We have talked about eye protection many times in the past. There is no question of how fragile our eyes are and how important it is to protect them. We all know when to wear eye protection on the job, but today we want to talk about other eye injuries that occur and how to prevent them. The majority of eye injuries do not occur because we failed to wear safety glasses. In fact, many eye injuries occur when safety glasses are being used. Today, we want to look at different ways eye injuries occur on the job. Let’s look at some history of actual eye injuries, their causes, and answer the question: “How do eye injuries happen when safety glasses are being worn?”

n

n
1. n

   Glasses being worn improperly. Wearing glasses down on the nose will not properly protect the eyes. This often happens when your safety glasses are too dirty, scratched, or fogged up. Take care of your glasses and replace them when necessary.

   n

n

2. n

   Even when glasses are worn properly, ‘cutting’ your eyes and looking over the top of your glasses creates an opening for debris to fall. Bend your neck and look directly at your work.

   n

n

3. n

   When operating a screw gun just above the ground, we often have to turn the screw gun sideways. The vent from the gun can easily blow dust or metal shavings on the ground up into your eye.

   n

n

4. n

   When lifting any kind of material overhead, debris on the material often falls off and into the eye. Even with glasses on, debris from above can easily fall behind your glasses.

   n

n

5. n

   Remember, we work in hot conditions and we all tend to sweat. If you do not keep your face, especially your forehead, clean, the perspiration can easily ‘wash’ debris into your eye.

   n

n

6. n

   Along that same line, we often reach up and wipe the sweat from our eyes with our hands. Many times, debris from your hand is actually rubbed into the eye.

   n

n

7. n

   We often work in windy conditions, (i.e. window openings, elevator shafts, fans, etc). Wind blows debris into the air as well as into the eye.

   n

n

8. n

   When cutting metal or screwing overhead, the metal shavings often fly or fall onto our hardhats, or even settle on the top of our safety glasses. In addition, we often use full-face shields to protect our eyes. When we take our hat off or raise the face-shield, the debris falls directly over the eyes. You should always bend over, take your hardhat & glasses off, and clean them before you proceed.

   n

n

n

Remember, safety glasses are actually designed to absorb or deflect flying debris. As we just discussed, there not designed to be a total protection for every exposure we face every day. As you know, many jobs require the use of safety glasses 100% of the time. We have long recognized that cutting and screwing metal, operating cutting tools and powder actuated tools, and working overhead present a very real eye hazard and have taken the proper steps to protect ourselves. The hazards listed above are not so obvious, however, they account for the vast majority of eye injuries.

n

As with all safety issues, knowledge and awareness are the keys. Preventing all eye injuries depends on all of us being aware of the many possibilities of exposures, recognizing them, and taking the proper steps to eliminate the exposure.

n